Proel PC260 Bedienungsanleitung PDF herunterladen (Seite 32)

USB2CAN converter

To work with a Pronet network you need a USB2CAN converter that converts the USB data ﬂow into the CAN bus. The USB2CAN

converter needs to be connected to a USB 2.0 full speed port.

USB2CAN Features:

ARM7 microcontroller inside

Galvanic isolation 500 V

Voltage supply via USB bus

USB 2.0 full speed

High productivity on 1Mbit CAN bus speed

Wide CAN bus baud rate range: 10-1000 Kbit/s

Compliant with CAN speciﬁcations 2.0A (11-bit ID) and 2.0B (29-bit ID)

Firmware upgrade via bootloader

Drivers for Windows 2000, Windows XP, Windows Vista,Windows 7

ToinstallcorrectlythesoftwaredriverfortheUSB2CANconvertersee"Installation"and"Drivers"paragraphsintheincludedoronline

ducumentation.

When you connect the converter to the USB port of the PC, the LED on the top lights RED: this mean that it is powered but the converter

is not working yet.

Thersttimeyougo"online",thePronetsoftwareapplicationstartstocontrolthenetworkviatheUSB2CANcontroller,sendingand

receiving datas from connected devices. If everything is OK the LED on the top of the converter lights GREEN indicating the activities

on the network.

If there is a problem with the software driver, with network bus or there is a problem on the converter the LED ﬂashes red and/or green.

STATUS LED operation

RED/GREEN toggling PC USB driver isn't installed

RED steady converter is not working

GREEN steady converter is working

GREEN blinking slow there is a problem in the bus

GREEN blinking fast there is a problem in the bus

RED blinking slow there is a problem in the bus

RED and GREEN steady Service mode

1 2 ... 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Proel PC260 Bedienungsanleitung Seite 32